Transparent waterproof adhesive tape for kitchen and bathroom joints

The easiest transparent waterproof tape to install Sanitary seals remain THE solution for good sealing of kitchen and bathroom elements.  However, if they are poorly done, water will seep in and cause a water leak, which is when mold can appear.  The use of household products can also damage them and alter their waterproofness.  Their degradation is even more rapid in the kitchen where they are subjected to grease splashes, on which dirt accumulates.  These then require regular cleaning which ends up damaging and crumbling them.  For better hygiene it is inevitable to change them.  The sealing tape, made of plastic, is very easy to maintain.  It is perfectly resistant over time to water, mold and household products used in the bathroom and kitchen.  Available in 3 sizes, it adapts to all your installations.  Features Ribbon length: 3m.  Width: 2cm / 3cm or 5cm.  A clean and aesthetic result It is often difficult to make a perfectly smooth and regular silicone joint between a water point (bathtub, shower tray, sink, etc.) and a worktop or tiled surface.  This roll seal provides a practical solution for sealing surfaces in a few minutes, without getting your hands dirty or damaging your walls, and obtaining a perfectly smooth and aesthetic result.  Presented in the form of a ribbon, made of flexible plastic, ensures optimal adhesion to surfaces.  Its powerful adhesive strip provides a perfect seal, eliminating the risk of water infiltration.  Thanks to its preformed angle, the tape is ready to use, extremely quick to apply and only requires a pair of scissors or a cutter to apply.  For optimal adhesion, it is recommended to first remove the old seal and properly clean the surface to be protected.  For easy application, the finger follows the joint perfectly in the hollow of its rounded shape.  Finally, for neat and discreet connections in the corners, cut the tape at 45°.  The joint perfectly matches the surface, corners and corners, and provides a neat, straight and clean finish.  After applying the seal, a waiting period of 8 hours must be respected before using the water point.