Semi-permanent nail polish Mono Clear 10 ml

The 2 in 1 semi-permanent nail polish works as a base semi-permanent nail polish and a top semi-permanent nail polish. All in one product, with extreme adhesion on the natural nail, used as a base and with the sublime shine used as a finish of the colored semi-permanent nail polishes!             The Mono Clear semi-permanent nail polish comes in a very elegant glossy black bottle with a high quality brush attached so as to make the application simpler and faster than semi-permanent procedures with separate products (Base and Top); The characteristic of having a very low viscosity guarantees the application of a minimal layer during application, with a notable saving in product, while still maintaining its high characteristics. Mono Clear, having a very low viscosity, is characterized by being self-levelling and very flexible and this allows it to adapt perfectly to the natural nail.             The application must be carried out with the utmost care not to touch the cuticles, to guarantee a better hold of the product and prevent detachment or premature defects of the finished nail. Catalyzation Times: UV lamp 3 Min/ LED 60 Sec. ​No.B.  If you wish to use a lower power lamp, you will need to pay more attention to the correct exposure of the treated finger to UV rays and evaluate the exposure time in proportion to the power of the lamp used for the processing of the single-phase semi-permanent. ( example approximately 4/6 minutes with a 9 Watt lamp).             APPLICATION SUMMARY Semi-permanent nail polish Mono Clear Single-phase system: - Push the cuticles (cuticles) with a cuticle pusher or an orange stick and remove them if necessary with the help of a cuticle nipper; - Pass a Buffer or Preparation File over the Natural Nail to prepare the surface for the treatment by gently roughening the surface.  The correct preparation of the nail for semi-permanent nail polish takes a few seconds and is considered finished when the surface of the nail is completely opaque.  This step is fundamental as in order to adhere perfectly to the natural nail, the semi-permanent nail polish requires a rough and dry surface; - Degrease the surface with a small square of pressed cotton soaked in Nail Cleaner; - Apply the Nail Prep and then the Primer; - Apply a very light layer of Mono Clear semi-permanent nail polish (as if it were a normal nail polish) as a base and pass under a 36 Watt UV lamp for 3 minutes or LED for 60 seconds; - Apply the color of semi-permanent nail polish that you prefer among those present in the Pics Nails range, then proceed with the exposure in a 36 Watt UV lamp for 3 minutes or LED 90 sec; - According to your or the client's taste, it is possible, to intensify the shade of some colours, to apply a second layer of product followed by a 3-minute lamp or 90 sec LED lamp; - Seal with Mono Clear semi-permanent nail polish and leave to catalyze for the necessary times; We remind you that the product, after being exposed to the rays of the UV lamp, produces a layer of dispersion (sticky film), which we recommend removing with pressed cotton soaked in Nail Cleaner Pics Nails only when used as a Top, as in the previous phases (base and Color or French application) is not mandatory. Product packaging: 10 ml bottle